Netgear GA620 Guia de Instalação Página 9

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 13
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 8
Model GA620 Gigabit Ethernet Card Installation Guide for Windows NT
8.
Refer to the table to set the parameters in the entry fields.
Entry Field Description
NIC Detected Adapter Instance: To distinguish multimode network cards installed
in the system, each is assigned a unique instance number.
Typically, the first network card detected is instance 1, and the next
is instance 2.
Bus: Shows on which PCI bus the network card is operating. The
number shown is typically 0 for a system with up to 4 PCI slots on
its bus. The number may be slightly higher for servers with more
than 4 PCI slots.
Slot: Shows the PCI slot number where the Model GA620 Gigabit
Ethernet Card is installed.
Link
Negotiation
Enabled
When checked (default): 802.3z-compliant Gigabit Ethernet Link
Negotiation is used. All Model GA620 Gigabit Ethernet Cards use
Link Negotiation by default.
When unchecked: Link Negotiation is disabled and only link signal
detection is used. Use this setting when connecting to Gigabit
Ethernet equipment that does not support Link Negotiation or if
there is a problem establishing a link between the card and the
connecting device. The link is set for 1000 Mbps full-duplex mode.
Be sure that the connecting device uses the same duplex mode
and speed settings.
Rx Flow
Control
Enabled
When checked (default) and link negotiation is enabled: The card
negotiates 802.3x receive flow control with the device at the other
end of the link. If 802.3x flow control is supported by the other
device, receive flow control is enabled.
When unchecked or link negotiation is disabled: Receive flow
control is disabled.
Tx Flow
Control
Enabled
When checked and link negotiation is enabled: The card negotiates
802.3x transmit flow control with the device at the other end of the
link. If 802.3x flow control is supported by the other device, transmit
flow control is enabled.
When unchecked (default) or link negotiation is disabled, transmit
flow control is disabled.
Vista de página 8
1 2 3 4 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários