Netgear AC750 Manual do Utilizador descarregar pdf (Página 133)

Advanced Settings

133

A750 Wireless Dual Band Gigabit Router JR6150

As an example of when a static route is needed, consider a situation with the following

elements:

• Your primary Internet access is through a cable modem to an ISP.

• You have an ISDN router on your home network for connecting to the company where

you are employed.

This router’s address on your LAN is 192.168.1.100.

• Your company’s network address is 134.177.0.0.

When you first configured your

router, two implicit static routes were created. A default route

was created with your ISP as the gateway

, and a second static route was created to your

local network for all 192.168.1.x addresses. With this configuration, if you attempt to access a

device on the 134.177.0.0 network, your router forwards your request to the ISP. The ISP

forwards your request to the company where you are employed, and the company’s firewall

denies the request.

In this case you must define a static route, telling your router that 134.177.0.0 should be

accessed through the ISDN router at 192.168.1.100.

This example

assumes the following

settings:

• The Destination IP Address

and IP Subnet Mask fields specify that this static route

applies to all 134.177.x.x addresses.

• The Gateway IP Address

field specifies that all traffic for these addresses should be

forwarded to the ISDN router at 192.168.1.100.

• A metric value of 1 works because the ISDN router is on the LAN.

• The Private

check box

is selected only as a precautionary security measure in case RIP

is activated.

 To set up a static route:

1. Log in to the router.

For more information, see

Use NETGEAR genie after Installation on page 17.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 158 159

Sem comentários

Netgear AC750 Manual do Utilizador Página 133