Netgear 802.11g Manual do Utilizador descarregar pdf (Página 33)

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

Basic Installation and Configuration 3-10

September 2004

Note: By default, WG302 is set to with the DHCP client disabled. If your network uses

dynamic IP addresses, you will need to change this setting.

d. Connect the power adapter to the wireless access point and plug the power adapter in to a

power outlet. The PWR, LAN, and Wireless LAN lights and should light up.

4VERIFY WIRELESS CONNECTIVITY

Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless

settings needed to connect to the WG302 (SSID, WEP/WPA, MAC ACL, etc.), verify

connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet,

or check for file and printer access on your network.

Note: If you are unable to connect, see Chapter 6, “Troubleshooting.”

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 107 108

Sem comentários

Netgear 802.11g Manual do Utilizador Página 33