Netgear WG602v3 Guia do Utilizador descarregar pdf (Página 53)

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual

Advanced Configuration 4-5

v1.0, August 2006

2. Under Advanced on the main menu, click Wireless Bridging. The Wireless Bridging screen

will display showing the default settings for the wireless access point.

3. Select the Wireless Multi-Point Bridging radio button to enable multi-point bridging.

4. Enter the MAC address of the first wireless access point and click Add. The AP’s MAC

address and connection information will appear in the Wireless Accept Point List.

You can add wireless access points to the list for a total of four. (These wireless access points

must be configured for Multi-Point Bridging.)

5. Check the Enable Wireless Client Association radio box to allow wireless clients access to

this wireless access point.

6. Click Apply to save your changes.

To delete a remote AP from the list, click Delete adjacent to the AP’s MAC address in the Wireless

Remote Access Point List.

The following figure illustrates a multi-point bridge setup over three LAN segments.

To configure wireless access points in a multi-point configuration:

1. Set the Operating Mode of the three Wireless APs as follows:

• Configure AP2 on LAN Segment 1 in Point-to-Point Bridge Mode. Enable Wireless Client

Association and add the Remote MAC Address of AP1 on LAN Segment 2.

Figure 4-4

AP2

AP1

AP3

LAN

Segment 1

LAN

Segment 2

LAN

Segment 3

PCs

Router

Hub or Switch

Wireless PC Card

in a Notebook Computer

192.168.0.1

Internet

Point-to-Point

Bridge Mode

Point-to-Point

Bridge Mode

Multi-Point

Bridge Mode

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 75 76

Comentários a estes Manuais

Sem comentários

Netgear WG602v3 Guia do Utilizador Página 53

Comentários a estes Manuais

Manuais e produtos relacionados com Pontos de acesso WLAN Netgear WG602v3