Netgear WAG102 Manual do Utilizador descarregar pdf (Página 80)

ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)

4-4 Advanced Configuration

v2.0, September 2006

• Wireless Point-to-Multi-Point Bridge. Select this only if this WAG102 is the “Master” for a

group of Bridge-mode Wireless Stations. The other Bridge-mode Wireless Stations must be set

to Point-to-Point Bridge mode, using the MAC address of this WAG102. They then send all

traffic to this “Master”, rather than communicate directly with each other. WEP can (and

should) be used to protect this traffic.

• Repeater. If selected, this wireless access point will operate as a Repeater only, and send all

traffic to the remote access point. If selected, you must enter the MAC address (physical

address) of the remote access point.

The screens used to configure these options are located by selecting Access Point Settings 11a or

Access Point Settings 11b/g under Advanced on the main menu (see Figure 4-3 below.

The screens used to configure these wireless access point modes are shown in Figure 4-3 above,

and described in the following sections.

Figure 4-3

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 101 102

Sem comentários

Netgear WAG102 Manual do Utilizador Página 80