Netgear WNDAP350 Manual do Utilizador descarregar pdf (Página 68)

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual

3-2 Management

v1.1, November 2009

To set up an SNMP management interface:

1. Under the Maintenance tab, select Remote Management, and then select SNMP from the

left sidebar. The SNMP screen displays, as shown in Figure 3-1 below:

2. Enter the following information in the SNMP fields:

•SNMP: Enable SNMP to allow the SNMP network management software, such as HP

OpenView, to manage the wireless access point via SNMPv1/v2 protocol.

• Read-Only Community Name: The community string to allow the SNMP manager to

read the wireless access point's MIB objects. The default is Public.

• Read-Write Community Name: The community string to allow the SNMP manager to

read and write the wireless access point's MIB objects. The default is Private.

• Trap Community Name: The community string to allow the SNMP manager to send

traps. The default is trap.

• IP address to Receive Traps: The IP address of the SNMP manager to receive traps sent

from the wireless access point.

• Trap Port: The port number on which the SNMP Manager will receive traps. The default

is 162/UDP.

Figure 3-1 Configure SNMP settings

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 135 136

Sem comentários

Netgear WNDAP350 Manual do Utilizador Página 68