Netgear GS728TP Manual do Utilizador descarregar pdf (Página 385)

100

101

Managing Device Security

385

ProSafe M5300 Switch

4. To remove an access profile, select the Remove Profile check box. The access profile

should be deactivated before removing the access profile.

5. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

6. If you make changes to the page, click APPLY to apply the changes to the system.

The Profile Summary table shows the rules that are configured for the profile, as the following

table describes.

Field Description

Rule Type Identifies the action the rule takes, which is either Permit or Deny.

Service Type Displays the type of service to allow or prohibit from accessing the switch

management interface:

• SNMP

• HTTP

• HTTPS

Source IP Address Displays the IP Address of the client that may or may not originate

management traffic.

Mask Displays the subnet mask associated with the IP address.

Priority Displays the priority of the rule. The rules are validated against the incoming

management request in the ascending order of their priorities. If a rule

matches, action is performed and subsequent rules below are ignored.

Click REFRESH to update the page with the most current information.

Access Rule Configuration

Use the Access Rule Configuration page to configure the rules about what systems can

access the ProSafe M5300 Web interface and what protocols are allowed.

To access the Access Rule Configuration page, click Security  Access, and then click the

Access Control

 Access Rule Configuration link.

Before you create access rules, make sure:

• An access profile exists.

• The access profile is deactivated.

To configure access profile rules:

1 2 ... 380 381 382 383 384 385 386 387 388 389 390 ... 529 530

Comentários a estes Manuais

Sem comentários

Netgear GS728TP Manual do Utilizador Página 385

Comentários a estes Manuais

Manuais e produtos relacionados com Software Netgear GS728TP