Netgear WNDAP380Rv2 Manual do Utilizador descarregar pdf (Página 27)

Installation and Basic Configuration

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

5. Specify the remaining wireless settings as explained the following table:

Setting Descriptions

Wireless Network Name

(SSID)

Enter a 32-character (maximum) service set identifier (SSID); the characters are

case-sensitive. The default is

NETGEAR_11ng. The SSID assigned to a wireless

device needs to match the wireless access point’s SSID for the wireless device

to communicate with the wireless access point. If the SSIDs do not match, you

do not get a wireless connection to the wireless access point.

Wireless On-Off Status This field is not configurable. It shows the status of the wireless scheduler. For

more information, see Schedule the Wireless Radios to Be Turned Off on

page 60.

Broadcast Wireless

Network Name (SSID)

Select the Ye

s radio button to enable the wireless access point to broadcast its

SSID, allowing wireless clients that have a null (blank) SSID to adopt the

wireless access point’s SSID.

Yes is the default setting. To prevent the SSID

from being broadcast, select the No radio button.

Channel / Frequency From the drop-down menu, select the channel you wish to use for your wireless

LAN.

The wireless channels and frequencies depend on the country and

wireless mode. The default setting is

Auto.

MCS Index / Data Rate

11ng mode only

From the drop-down menu, select a Modulation and Coding Scheme (MCS)

index and transmit data rate for the wireless network.

The default setting is Best.

For a list of all options that you can select, see Factory Default Settings

page 127.

Channel Width From the drop-down menu, select a channel width. The

options are Dynamic 20/40 MHz, 20 MHz, and 40 MHz.

The

default is 20 MHz. A wider channel improves the

performance, but some legacy devices can operate only in

either 20 MHz or 40 MHz.

Guard Interval From the drop-down menu, select the guard interval to

protect transmissions from interference.

The default is Auto,

or you can select Long - 800 ns. Some legacy devices can

operate only with a long guard interval.

Output Power From the drop-down menu, select the transmission power of the wireless access

point: Full, Half, Quarter

, Eighth, Minimum. The default is Full.

Note:

It should not be necessary to change the wireless channel unless you

experience interference (indicated by lost connections or slow data transfers). If

this happens, you might want to experiment with different channels to see which

is the best. For more information, see Operating Frequency (Channel)

Guidelines on page 25.

Note: For more information about available channels and frequencies, see

Technical Specifications on page 125.

Note: For most

networks, the default

settings work fine.

Note: Increasing the power improves performance, but if two or more wireless

access points are operating in the same area and on the same channel,

interference can occur.

Note: Make sure that you comply with the regulatory requirements for total radio

frequency (RF) output power in your country.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 151 152

Comentários a estes Manuais

Sem comentários

Netgear WNDAP380Rv2 Manual do Utilizador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Pontos de acesso WLAN Netgear WNDAP380Rv2